https://wiki.arcadeotaku.com/index.php?action=history&feed=atom&title=Taito_Stereo_AmpTaito Stereo Amp - Revision history2026-04-04T01:09:52ZRevision history for this page on the wikiMediaWiki 1.42.1https://wiki.arcadeotaku.com/index.php?title=Taito_Stereo_Amp&diff=6596&oldid=prevDavewellington: Removing game hardware cat.2012-08-08T04:57:49Z<p>Removing game hardware cat.</p>
<p><b>New page</b></p><div>Stereo amplifier. Direct fitting to [[Taito Egret 3]] and [[Sammy Atomiswave SD]] cabinets.<br />
<br />
Has a JST VH (B2PS-VH) connector for power and JST NH (BS 6P-SHF-1AA) connector for speaker output, with 2 phono connections for audio in.<br />
<br />
[[Image:Taito_Stereo_Amp_AWSD_E3.jpg|200px]]<br />
<br />
== Installation in [[Taito Egret II]]==<br />
[[Image:Taito_Stereo_Amp_Egret_2.jpg|200px|right]]<br />
To connect the amplifier to a [[Taito Egret II]] requires a small modification to the cabinet wiring. Obtain a 6 pin JST NH female connector and move the pins from the Egret's 4 pin F connector as shown - colours Black, Green, Red, Yellow. Using a 2 pin JST VH female connector, wire up +12V DC from the cabinet PSU to pin 1, but do not wire the a PSU ground to pin 2 (this eliminates the ground hum/noise that is present when both are connected). The cabinet can then be switched to stereo and audio is sourced from the amp.<br />
<br />
If using [[Capcom]] [[CPS2]] boards set to stereo you should blank off the standard [[JAMMA]] speaker connections (pins 10 and L) as these output mono at the same time, and the Egret has this connected to the left stereo channel. Not doing this will give distorted stereo sound.<br />
<br />
[[Category:Tutorials]]<br />
[[Category:Pinouts]]</div>Davewellington