Nanao MS8-29: Difference between revisions
Jump to navigation
Jump to search
mNo edit summary |
No edit summary |
||
| (5 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
[[Category:Monitors]] | [[Category:Monitors]] | ||
[[Category:Repairs]] | [[Category:Repairs]] | ||
[[File:Nanao_MS8-29_Monitor_Chassis.jpg|200px|thumb|right|Nanao MS8-29FTB Monitor Chassis]] | |||
Arcade monitor found in [[Sega Astro City]], [[Taito Egret 29]] and many more early 90's cabs. | |||
*Size: 29" curved Tube | |||
*Sync: 15/24 kHz (set by moving yoke connector) | |||
==Cap Kits / Guides== | |||
=== Nanao MS8-29FSG=== | |||
* [[Nanao_MS8-29FSG|Nanao MS8-29FSG Cap Guide and Measurements]] | |||
* [https://github.com/phrederick/nanao_ms8-29fsg_capmap NANAO MS8-29FSG Electrolytic Capacitor Location Reference (external link)] | |||
==Setting B+== | |||
Set to +94V using the "+B Adjust" potentiometer, located below the metal shield close to the flyback. | |||
Measure between TP1 and TP2, located close to the middle fuse. | |||
==Repair== | ==Repair== | ||
| Line 22: | Line 35: | ||
If full vertical frame collapse then also change R436 Q401 Q402 C437 | If full vertical frame collapse then also change R436 Q401 Q402 C437 | ||
==Manuals== | ==Manuals== | ||
Latest revision as of 18:58, 9 December 2024
Arcade monitor found in Sega Astro City, Taito Egret 29 and many more early 90's cabs.
- Size: 29" curved Tube
- Sync: 15/24 kHz (set by moving yoke connector)
Cap Kits / Guides
Nanao MS8-29FSG
- Nanao MS8-29FSG Cap Guide and Measurements
- NANAO MS8-29FSG Electrolytic Capacitor Location Reference (external link)
Setting B+
Set to +94V using the "+B Adjust" potentiometer, located below the metal shield close to the flyback.
Measure between TP1 and TP2, located close to the middle fuse.
Repair
Looks like sync has gone but clears after a while or after repowering, also may encounter some size issues
Change C911 C913 C422
Poor colour definition with brightness issues, sometimes intermittent
Change C332
Monitor does not power up or cuts out
There are many reasons for this, here are some that I know of:
Check the fuses first
If you get a line across the horizontal and then the chassis shuts down then there is a fault on the vertical deflection circuit
Signs of frame foldover
Change C433 R433
If full vertical frame collapse then also change R436 Q401 Q402 C437
